HP Jetdirect 310x - Print Server For Fast Ethernet User Manual page 75

Controls the filtering of syslog messages that are sent to the syslog
server. The filter range is 0 to 8, with 0 being the most specific and
Syslog
8 being the most general. Only messages that are lower than the
Priority
filter level specified (that is, higher in priority) are reported. The
default value is 8 which reports all syslog messages. A value of
zero effectively disables syslog reporting.
Specifies the number of seconds that an idle print connection is
allowed to remain open. Up to 3600 seconds can be set. 270 is the
Idle Timeout
default value. If set to 0, the timeout is disabled and TCP/IP
connections will remain open until closed by the device at the other
end of the network (for example, a workstation).
Specifies the IP multicast Time To Live (TTL) discovery setting
for Service Location Protocol (SLP) packets (used by the HP
TTL/SLP
Jetdirect Install Network Printer Wizard). The default value is 4
hops (the number of routers from the local network). The range is
1-15. If set to -1, multicast capability is disabled.
Identifies a person who is assigned to administer or service this
System
device. This field may include a phone number or similar
Contact
information. When configured, this parameter will be displayed on
the HP Jetdirect Home page.
Specifies the physical location of the device or related information.
System
Only printable ASCII characters are allowed, up to 64 characters.
Location
When configured, this parameter will be displayed on the
HP Jetdirect Home page.
Specifies whether to enable or disable printing of an LPD banner
Banner Page
page for print jobs.
IPX/SPX settings
Networking
Click on the
Configuration
in the left column of the page,
IPX/SPX
the tab in the second row of tabs across the page. To assign a parameter
setting, enter the desired value and click
IPX/SPX
Enables or disables the IPX/SPX protocols on the print server. If
Enable
the checkbox is empty, IPX/SPX is disabled.
tab at the top of the web page. (Make sure that beneath
Network Settings
[Apply]
IPX/SPX Settings
is selected.) Select
.