Configuring Pots Dial Peers On Mgcp Gateways; Restrictions For Pots Dial Peers On Mgcp Gateways - Cisco VGD-1T3 Software Configuration Manual

Using Cisco Unified Communications Manager to Configure MGCP Gateway Support
The following example shows one Cisco Unified Communications Manager backup server is configured.
Switchback mode is set for immediate return to the primary Cisco Unified Communications Manager
server as soon as the server is available.
Router# show ccm-manager
MGCP Domain Name: router.cisco.com
Total number of host: 2
Priority
===================================================
Primary
First backup
Second backup
Current active Communications Manager: 10.0.0.201
Current backup Communications Manager: 10.0.0.50
Redundant link port:
Failover Interval:
Keepalive Interval:
Last keepalive sent:
Last MGCP traffic time:
Last switchover time:
Switchback mode:
Step 3 show ccm-manager fallback-mgcp
Use the show ccm-manager fallback-mgcp command to verify whether MGCP fallback is enabled and
whether it is active or not (on or off), for example:
Router# show ccm-manager fallback-mgcp
Current active Communications Manager:
MGCP Fallback mode:
Last MGCP Fallback start time: 00:00:00
Last MGCP Fallback end time:
For a description of the fields displayed in these output examples, see descriptions of the individual
Note
commands in the

Configuring POTS Dial Peers on MGCP Gateways

Perform this task to enable the POTS dial peers on your MGCP gateway to communicate with
Cisco Unified Communications Manager.
When you have finished this procedure, the voice gateway is ready to communicate with Cisco Unified
Communications Manager. It periodically sends out messages attempting to establish a connection.
When the Cisco Unified Communications Manager configuration is complete, the connection should
automatically establish itself. You should not have to make any further changes on the MGCP gateway.

Restrictions for POTS Dial Peers on MGCP Gateways

•
Status
Registered
Backup polling 10.0.0.50
Undefined
Cisco IOS Voice Command
All dial-plan configuration elements are controlled by Cisco Unified Communications Manager and
should not be configured on the MGCP gateway for MGCP-managed endpoints (that is, any
endpoint with an application mgcpapp command in its associated dial peer).
Host
10.0.0.201
2428
30 seconds
15 seconds
00:20:18 (elapsed time: 00:00:06)
00:20:18 (elapsed time: 00:00:06)
None
Immediate
10.00.71.29
Enabled/OFF
00:00:00
Reference.
Cisco VGD 1T3 Voice Gateway Software Configuration Guide
Configuring MGCP Gateway Support
129