Yamaha 02R Version 2 Manual page 84

3. Use the [AUTOMIX] button to locate the AUTOMIX 3/7 page.
This display allows you to watch the fader movements as dynamic
bargraphs. Several features make this display convenient to use while you
perform detailed fader/encoder edits.
4. Use the CURSOR buttons to select "Fader Edit Out—RET" and press
[ENTER] to change its value.
If the RET check box is not selected, you may want to move the fader back
to its previously recorded level before you punch-out. If the RET check box
is selected, the fader will automatically return to the previously recorded
level when you punch out. The time it takes to return to the previous level
is controlled by the "Time" field.
5. Select the "REC" icon with the CURSOR buttons and press the
[ENTER] button.
The "REC" icon will flash.
6. Start the device that is providing the timecode.
The 02R will remain in AUTOMIX RECORD READY status.
7. Monitor the recording. At the punch-in location, press the [SEL]
button for the tape return channel you want to edit.
Recording will begin from where you pressed the [SEL] button.
8. While monitoring the recording, adjust the fader you want to edit.
As you operate the fader, the display shows the previously recorded
position as well as the new position. An arrow in the display indicates the
Mixing and Automix
02R Getting Started Guide
79