C18A_ENG_europe_17"_film
ENG
Rear of the TV
10/10/03
4:11 PM
Inserting the Batteries in the Remote Control
You must insert or replace the batteries in the remote control when
you:
Connecting to an Aerial or Cable Television Network
To view television channels correctly, a signal must be received by
the set from one of the following sources:
or
Cable Television
Network
10
Page 10
Purchase the television
Find that the remote control is no longer operating
correctly
1
Remove the cover on the rear of the remote control by pressing
the symbol (
) downwards and then pulling firmly to remove it.
2
Insert two R03, UM4, "AAA" 1.5V or equivalent batteries taking
care to respect the polarities:
+ on the battery against + on the remote control
- on the battery against - on the remote control
3
Replace the cover by aligning it with the base of the remote
control and pressing it back into place.
An outdoor aerial
A cable television network
A satellite network
1
In the first three cases, connect the aerial or network input cable to
the 75Ω coaxial socket on the rear of the television.
2
If you are using an indoor aerial, you may need to turn it when
tuning your television until you obtain a picture that is both sharp
and clear.
For further details, refer to:
"Storing Channels Automatically" on page 16
"Storing Channels Manually" on page 17