Multiscr Mode - Panasonic AJ-FX216 Operating Instructions Manual

MULTISCR Mode

Select this mode to monitor the camera pictures.
Selection of MULTISCR mode permits the following
operations.
Monitoring the camera picture
A. Single Spot Picture
Proceed as described in "Monitoring the Camera
Picture, A. Single Spot Picture" on page 15.
B. Multi Spot Picture
1. Set the MODE SELECT/CAMERA SELECT switch to
CAMERA SELECT.
2. Press the ZOOM/MULTISCREEN/QUAD SHIFT but-
ton. The multiscreen appears on the monitor.
3. Set the MODE SELECT/CAMERA SELECT switch to
MODE SELECT.
4. Press button 1 ( ), 2 (
multiscreen pattern (quad, 3x3, or 4x4).
Notes:
• Some frames are skipped as the picture seg-
ments are displayed.
• Multi spot pictures being monitored may some-
times vibrate vertically, but this does not indi-
cate a malfunction.
• Quad shift is available by pressing the ZOOM/
MULTISCREEN/QUAD SHIFT button. Refer to
page 17 for more details.
1
3
1
4
7
1 2
3 4
9 10
11 12
), or 3 ( ) to select
2
4
Quad
2 3
5 6
8 9
3 x 3
5 6
7 8
13 14
15 16
4 x 4
C. Single Spot or Quad Picture Sequences
You can monitor sequential spot pictures or quad
pictures. First select a display pattern.
To monitor sequential single spot pictures, take the
same steps as described in procedures B for
"Single Spot Picture Sequences of Monitoring
Camera Pictures" on page 15.
To monitor sequential quad pictures, proceed as
described in the following procedures.
1. Take steps 1 to 3 of Procedures B for Multi Spot
Pictures.
2. Press button 1 (
3. Press the SEQUENCE/ALARM RESET button. The
quad pictures appear sequentially in the order of
dwell times set in the SEQUENCE SETUP in MENU
3 OF 3.
Example of quad picture sequence
Camera 1
Picture
Camera 5
Picture
Camera 8
Picture
Camera 12
Picture
4. To cancel sequential picture display, press the
desired camera selection button.
camera picture appears on the single picture
screen of the monitor.
-20-
) to select quad pictures.
Camera 2
Picture
Camera 6
Picture
Camera 10
Picture
Camera 16
Picture
The selected