Installing The (Optional ) Antenna; Installing The Belt Clip - Kenwood TK-2140 Instruction Manual

I
NSTALLING THE
Screw the antenna into the
connector on the top of the
transceiver by holding the
antenna at its base and turning
it clockwise until secure.
I
NSTALLING THE
Note: When first installing the belt clip, you must remove the battery
pack from the rear of the transceiver.
1 Remove the two screws
from the rear of the
transceiver, then remove the
small, plastic black covering
that was held in place.
2 Insert the belt clip mount
into the space on the rear of
the transceiver.
3 Using the 2 screws, affix the
belt clip in place.
Note: Do not dispose of the plastic
black covering! If you remove the
belt clip, replace the covering into the
space on the rear of the transceiver.
Either this covering or the belt clip
must be in place, otherwise the
battery pack may not remain installed
properly.
(O ) A
PTIONAL
B C
ELT LIP
NTENNA
9