Connecting Wires To Terminals - Kenwood KDC-W7041U Instruction Manual

Connecting Wires to Terminals

USB connector (1m)
To USB device
⁄
Do not remove the cap when you do not use the USB
cable. The connector will cause the unit to malfunction
if it gets in touch with any metallic part of the vehicle.
REMO.CONT
⁄
To use the steering wheel remote control feature, you
need to an exclusive remote adapter (not supplied)
matches your car is required.
To External Display/ Steering remote
KDC-W7541U/W7041U only
Fuse (10A)
To Kenwood disc changer/External optional accessory
Wiring harness
(Accessory1)
TEL mute wire (Brown)
If no connections are made, do not
let the wire come out from the tab.
Power control/Motor antenna
control wire (Blue/White)
Battery wire (Yellow)
Ignition wire (Red)
A–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
8 6 4 2
7 5 3 1
8 6 4 2
Connector B
7 5 3 1
Steering remote control (Light
Blue/Yellow)
KDC-W7541UY/W7141UY only
FM/AM antenna input (JASO)
AUX input (Stereo)
Use the mini-plug which is stereo type and does not have
any resistance.
MUTE
P.CONT
ANT.CONT
See next page
KDC-W7541U/KDC-W7541UY
L R
Rear output
Front output
Sub Woofer output
KDC-W7041U/KDC-W7141UY
L R
Front output
Rear output/Sub Woofer output
Antenna Cord
Connect to the terminal that is grounded when
either the telephone rings or during conversation.
⁄
To connect the Kenwood navigation system,
consult your navigation manual.
Connect either to the power control terminal
when using the optional power amplifier, or to the
antenna control terminal in the vehicle.
27
|
English