Connecting With A Gps Receiver Or Weather Station; Adjusting The Internal Clock - Kenwood TM-D710A Manual

CONNECTING WITH A GPS RECEIVER OR WEATHER
STATION
The GPS jack on this transceiver accepts a 2.5 mm
(1/10") 3-conductor plug. If necessary, use the supplied
cable to modify the cable end of your GPS receiver or
Weather Station.
GPS receiver
To GPS jack
• In order to use the connected GPS receiver, access Menu
602 (GPS PORT - INPUT) to select "GPS", "WEATHER
((Davis) )" or "WEATHER (PeetBros. )".

ADJUSTING THE INTERNAL CLOCK

This transceiver has a clock to manage information on
when APRS packets are received. Use Menu Set-up to
correct the current time, date, and if necessary the UTC
offset; UTC stands for Universal Time Coordinated.
Note: The battery for the clock backup is built into the unit. When
the power source is connected, the battery begins to charge. It takes
approximately 12 hours to become fully charged.
n Setting Date
1 Enter Menu mode and access Menu 524.
• The first 2 digits blink.
2 Rotate the Tuning control to enter the current
month (K type) or day, then press the Tuning
control.
• The next 2 digits blink.
3 Rotate the Tuning control to enter the current day
(K type) or month, then press the Tuning control.
• The last 2 digits blink.
4 Rotate the Tuning control to enter the current year,
then press the Tuning control.
Weather Station
Shield
(to GND on GPS/ WX)
Red
(to DATA OUT on GPS/ WX)
White
(to DATA IN on GPS/ WX)
5 Press [ESC] to exit Menu mode.
Note:
u When used at room temperature (25°C), the error of the internal
clock in a month is within one minute.
u The internal clock is effective until December 31, 2099.
n Setting Time
1 Enter Menu mode and access Menu 525.
• The first 2 digits blink.
2 Rotate the Tuning control to enter the current hour,
then press the Tuning control.
• To set 1 o'clock PM for example, select 13.
• The next 2 digits blink.
3 Rotate the Tuning control to enter the current
minute, then press the Tuning control.
4 Press [ESC] to exit Menu mode.
n Setting UTC Offset
1 Enter Menu mode and access Menu 526.
2 Rotate the Tuning control to select the appropriate
UTC offset, then press the Tuning control.
• The selectable range is from +12:00 to –12:00 in steps
of 15 minutes.
3 Press [ESC] to exit Menu mode.
APRS-