Port Configuration Examples; Configuring Port Settings - Dell PowerEdge M420 Configuration Manual

Command
action {down|up}
CTRL + Z
show link-dependency
group_id
[group

Port Configuration Examples

This section contains the following examples:
•

Configuring Port Settings

• Configuring a Link Dependency Groups
Configuring Port Settings
The commands in this example specify the speed and duplex mode for port 1
(gigabitethernet 1/0/1) and change the MTU size for ports 10, 11, 12, 20, and
25.
To configure the switch:
1 Enter Interface Configuration mode for port 1.
console#configure
console(config)#interface gigabitEthernet 1/0/1
2 Change the speed and duplex settings for the port.
console(config-if-Gi1/0/1)#speed 100
console(config-if-Gi1/0/1)#duplex full
console(config-if-Gi1/0/1)#exit
3 Enter Interface Configuration mode for ports 10, 11, 12, 20, and 24.
console(config)#interface range gigabitEthernet
1/0/10-12,1/0/20,1/0/24
506
Configuring Port Characteristics
Purpose
Specifies the action the member ports take when the
dependent link goes down.
• down—When the dependent link is down, the group
members are down (the members are up otherwise).
• up—When the dependent link goes down, the group
members are brought up (the members are down
otherwise)
Exit to Privileged EXEC mode.
View link dependency settings for all groups or for the
] specified group.