Installation; In This Chapter; Time And Items Required - Dell PowerConnect B-DCX-4S Backbone Hardware Reference Manual

Installation

In this chapter

Time and items required

You can set up and install the PowerConnect B-DCX-4S in the following ways:
•
•
•
•
This chapter describes how to set up the PowerConnect B-DCX-4S as a standalone unit. For
rack-mount installation instructions, refer to the appropriate manual as described in
Table 3
based on a fully populated PowerConnect B-DCX-4S (192 Fibre Channel ports). Configurations with
fewer ports require less time. These time estimates assume a prepared installation site and
appropriate power and network connectivity.
TABLE 3
Installation task
Site preparation and unpacking
PowerConnect B-DCX-4S.
PowerConnect B-DCX4S Backbone Hardware Reference Manual
53-1001808-01
•
Time and items required . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
•
Preparing for PowerConnect B-DCX-4S installation. . . . . . . . . . . . . . . . . . . . 12
•
Unpacking and installing the PowerConnect B-DCX-4S . . . . . . . . . . . . . . . . 13
•
Items included with the PowerConnect B-DCX-4S. . . . . . . . . . . . . . . . . . . . . 14
As a standalone unit on a flat surface.
In a chassis with the DCX-4S Port Side Exhaust Kit (provided) in a Brocade-qualified rack.
In a 19-in. Electronic Industries Association (EIA) cabinet, using a PowerConnect B-DCX-4S
Rack Mount Kit (either a 27-31 in. or 18-34 in. kit depending on rack used).
In a mid-mount telecommunications (Telco) rack, using the PowerConnect B-DCX-4S
Mid-Mount Rack Kit available from your PowerConnect B-DCX supplier (optional).
describes the main installation and setup tasks and the estimated time required for each,
Installation tasks, time, and items required
Time estimate Items required
30 minutes 1/2-in. socket wrench (to remove pallet bolts).
#2 Phillips screwdriver.
(for cable management comb).
Pallet jack.
Hydraulic lift or assisted lift, able to rise to a
minimum of 55 in. (140 cm), with a minimum
capacity of 113 kg (250 lb). The PowerConnect
B-DCX-4S weighs 68 kg (150 lb) with four
FC8-48 port cards installed (192 ports).
Chapter
2
Table 3.
11