Electrical Connection; Gas Conversion - Samsung GN642FFXD Installation And User Manual

Electrical Connection

■ This appliance must be earthed.
■ This appliance is designed to be connected to a 220~240V, 50/60Hz AC electricity supply.
■ The wires in the mains lead are coloured in accordance with the following code ;
- Green/yellow = Earth
- Blue = Neutral
- Brown = Live
■ The wire which is coloured green and yellow must be connected
to the terminal which is marked with the letter E or by the earth
symbol.
N
1
L
1. MICRO SWITCHES
2. IGNITER
220 1
2
3
0
4
2
23

Gas Conversion

■ Be careful, the operations and adjustments to be carried out when converting
from one gas to another.
■ All work must be carried out by a qualified technician.
■ Before you begin, turn off the gas and electricity supply to the appliance.
1
Change the injector of the burners.
Remove the pan support, Burner lid and Flame spreader.
Unscrew the injector using a 7mm box spanner and replace it with
the stipulated injector for new gas supply. ( see table 1. Page 25.)
Carefully reassemble the all components.
After injectors are replaced, it is advisable to strongly tighten the
injector in place.
Injector
2
Adjusting of the taps of the cooking hob burners for
reduced consumption
➀ Turn the taps down to minimum.
Control handle ➁ Remove the control handles from taps.
➂ Adjusting the by-pass screw.
Tap
Sealing ring
Tap
by-pass screw
➃ Replace the control handles on the taps.
■ Do not dismantle the tap shaft : in the event of a malfunction, change the whole tap.
■ Before placing the burners back on the top place, make sure that the injector is
not blocked.
■ A full operational test and a test for possible leakages must be carried out after
gas conversion. (such as soap water or gas detector)
■ After completing conversion, a qualified technician or installer has to mark "V"
on the right gas category
Tong Yang Magic
to match with the setting
in rating plate.
Remove the previous
setting "V" mark.
- For coverting G20 into G30 or G31, the screw must
be screwed down fully tight.
- At this stage, light up the burners and turn the
control handles from max position to minimum
position to check flame stability.
- For converting G30 or G31 into G20, please contact
"After-Sales Service".
MADE IN KOREA
GN641FFBD S/N: GN641FFBDES0003
G20/20rnbar 220-240V 50/60Hz
∑Qn Q20:7.5kW G30:521g/h G31:503g/h
GB Cat.:ll 2H3+
G20-20mbar G30/29mbar G31/37mbar
24
0063