Table of Contents
Advertisement
Chapter 6
Using OS/2
This chapter explains how to configure and use the Ethernet
Card with an IBM OS/2 System. See Chapter 1 for information
on hardware installation.
Installing on an OS/2 System
Before you set up the software, you must install the card in the
printer, connect it to the network, and turn on the printer.
Requirements
OS/2 Warp and Warp Connect must be installed with
NetBEUI protocol and OS/2 Warp Connect must be installed
with NetBIOS over TCP/IP protocol. EPSON Net! for OS/2
provides the following programs:
NETBEUI
RPRINT3, RSTAT3-LPT redirection
REMPRT3, REMBEU, RBMSTAT3-pipe support
TCP/IP
RPRINT, RSTAT-LPT redirection
REMPRT, REMSTAT-pipe support
Using OS/2 6-1
Advertisement
Table of Contents
