Table of Contents
Advertisement
2
Before Using the Cooktop
Fig= t
Fig, 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
ABOUTTHE DIANT SURFACE ELEMENTS
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
The element temperature
rises gradually and evenly. As the temperature
rises, the element
will glow red. To maintain the selected setting, the element will cycle ON and OFF. The heating
element retains enough heat to provide a uniform and consistent heat during the OFF cycle.
For efficient cooking, turn OFF the element several minutes before cooking is complete. This
will allow residual heat to complete the cooking process.
Radiantelementshaveali miterthat allowstheelementtocycleONand OFF,evenat the HIsetting.This helps
to preventdamageto the ceramicglass cooktop.Cyclingat the Ht settingis normaland can also occurif the
cookwareis toosmallfortheradiantelementor ifthe cookwarebottomis notflat (Refertopages15-16for using
correctcookwareinstructionswith the cooktop).
Pleaseread detailedinstructionsfor ceramicglass cooktopcleaningin the General Care & Cleaning section
and Solutions to Common Problems sectionof this Use and CareGuide.
LED MESSAGES DISP YED BY DIANT ELEMENT
[]
[]
[]
[]
[]
[]
[]
[]
[]
Ii
[]
[]
[]
[]
[]
[]
[]
[]
[]
I
[]
THE AVAILABLE
WINDOW DISPLAY SETTINGS =The control will display
heat levels ranging from Hi (Figure 1) to Lo (Figure 6) and OFF (Figure 7).
The settings between 9.5 (Figure 2) and 3.0 (Figure 3) decrease or increase in
increment of .5 (1/2). The settings between 3.0 (Figures 3 & 4) and 1.2 (Figure
5) are Simmer settings which decrease or increase in increment of .2 (1/5) to
Lo (Figure 6; lowest Simmer setting) for more precise settings at lower heat
levels. Use the Recommended
Surface Setting Chart to determine the correct
setting for the kind of food you are preparing.
HOT ELEMENT INDICATOR
MESSAGE (HE) - After using any of the single or
dual radiant element positions the cooktop witl become very hot. Even after turning
the control to OFF, the cooktop will remain hot for some time. The control monitors
the temperature of the cooktop and displays the message "HE" (hot element; See
Fig. 8) warning when the cook'top is still too hot to touch. If the HE message
appears in the window, the control can still be turned ON again for use.
KEEP WARM (LN) - Use the keep warm key pad to activate the warm settings
for any of the cooking zones The ON/OFF key pad for the desired cooking
zone must be activated first, then touch the warm key pad once to set the
Keep Warm function. LH (Low Heat) should appear in the corresponding
cooking zone display window (See Fig. 9),
Fig. 9
Hide quick links:
Advertisement
Table of Contents
