Connnecting A Digital Audio System; Connecting An Analog Audio System - Toshiba 50HM66 - 50" Rear Projection TV Installation Manual

DLP_Inst.book Page 16 Wednesday, February 22, 2006 6:18 PM
Connecting a digital audio system
The TV's DIGITAL AUDIO OUT terminal outputs a Dolby
Digital g or 2-channel down-mixed PCM (pulse-code
modulation) signal for use with an external Dolby
decoder or other external audio system with optical audio
input.
You will need:
• optical audio cable (Use an optical audio cable that has the
larger "TosLink" connector and not the smaller "mini-
optical" connector.)
Dolby Digital decoder or
other digital audio system
Optical
LINE IN
L R Audio IN
TV
To control the audio:
1
Turn on the TV and the digital audio device.
2
Press MENU on the TV's remote control and open the
Audio menu.
3
Highlight Audio Setup and press ENTER.
Audio
Audio Settings
Advanced Audio Settings
Audio Setup
4
In the Optical Output Format field, select either
Dolby Digital or PCM, depending on your device
-
( "Selecting the optical audio output format" in the
Operating Guide).
Audio Setup
MTS
Language
Speakers
Optical Output Format
Reset
16
Connecting your TV
5
®
*
Notes:
• Some audio systems may not be compatible with Dolby
®
Digital
• The DIGITAL AUDIO OUT terminal outputs signals only
• The DIGITAL AUDIO OUT terminal may not output some
* Manufactured under license from Dolby Laboratories. Dolby and

Connecting an analog audio system

This connection allows you to use external speakers with an
external analog audio amplifier to adjust the sound level.
You will need:
• standard audio cables
TV
To control the audio:
1
2
Stereo
English
On
Note: To hear sound when using an external audio amplifier,
Dolby Digital
the volume of both the TV and the amplifier must be set to a
reasonable listening level.
Done
Turn off the TV's built-in speakers in the same Audio
Setup menu. Also see "Turning off the built-in speakers"
in the Operating Guide.
Digital bitstream signals. Older audio systems that are not
compatible with standard optical out signals may not work
properly, creating a high noise level that may damage
speakers or headphones. THIS DAMAGE IS NOT COVERED
BY YOUR WARRANTY.
when receiving digital broadcasts with the TV in single-
window mode.
digital audio sources because of copy restrictions.
the double-D symbol are registered trademarks of Dolby
Laboratories.
Analog audio amplifier
LINE IN
L R
Turn on the TV and the stereo amplifier.
Turn off the TV's built-in speakers (
built-in speakers" in the Operating Guide).
-
"Turning off the
DLP Inst (E/F) Web 213:276