Advertisement
Table of Contents
MODEL S270T PRO™ SERIES HIGH-RATE SAND FILTER
Basic safety precautions should always be followed, including the following: Failure to follow instructions can cause severe
injury and/or death.
This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look for one of the
following signal words and be alert to the potential for personal injury.
WARNING
warns about hazards that could cause serious personal injury, death or major property damage and if
ignored presents a potential hazard.
CAUTION
warns about hazards that will or can cause minor or moderate personal injury and/or property damage
and if ignored presents a potential hazard. It can also make consumers aware of actions that are unpredictable and unsafe.
The NOTICE label indicates special instructions that are important but not related to hazards.
Use only High Rate Sand No. ½ Silica Sand (.45mm - .55mm)
HAYWARD POOL PRODUCTS, INC.
620 Division Street
OWNER'S MANUAL
INSTALLATION, OPERATION & PARTS
SAVE THIS INSTRUCTION MANUAL
Elizabeth, NJ 07207
WWW.HAYWARDPOOL.COM
Tel: 908-351-5400
IS270T-05
Rev. B
Advertisement
Table of Contents
Related Manuals for Hayward Pro Series Top-Mount
Summary of Contents for Hayward Pro Series Top-Mount
- Page 1 The NOTICE label indicates special instructions that are important but not related to hazards. SAVE THIS INSTRUCTION MANUAL Use only High Rate Sand No. ½ Silica Sand (.45mm - .55mm) HAYWARD POOL PRODUCTS, INC. 620 Division Street Elizabeth, NJ 07207 Tel: 908-351-5400 WWW.HAYWARDPOOL.COM...
- Page 2 – Electrical Ground motor before connecting to electrical power supply. Failure to ground pump motor can cause serious or fatal electrical shock hazard. – WARNING Do NOT ground to a gas supply line. WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
-
Page 3: How It Works
Also, contact a licensed electrician for information on local electrical codes for bonding requirements. Your Hayward Pro Series high-rate sand filter is a high securely in place on drain pipe). -
Page 4: Service And Repairs
SERVICE & REPAIRS filter will cause the pressure to rise and flow to diminish. Consult your local authorized Hayward dealer or service When the pressure gauge reading is 8-10 PSI (0.55-0.69 center. No returns may be made directly to the factory BAR) higher than the initial "clean"... -
Page 5: Specifications
MEDIA REQUIRED FILTRATION WORKING MODEL SIDE ABOVE TYPE AMOUNT AREA PRESSURE NUMBER INCH INCH FILTER SAND** S270T 3.45 0.45-0.55mm **Also known as No. 20 or No. ½ Silica Sand. TABLE 1 FIGURE B WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS... - Page 6 No action - chlorine will naturally dissipate Dilution - partially drain & refill pool with water CHLORINE STABILIZER 40 to 70 ppm Add Stabilizer that has not been treated with Cyanuric Acid. (Cyanuric Acid) WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
- Page 7 To obtain warranty replacements or repair, defective components or parts should be returned, transportation paid, to the place of purchase, or to the nearest authorized Hayward service center. For further Hayward dealer or service center information, contact Hayward customer service department. No returns may be made directly to the factory without the express written authorization of Hayward Pool Products, Inc.
- Page 8 Page 8 of 8 MODEL S270T IS270T-05 Rev B THIS PAGE LEFT BLANK WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
Need help?
Do you have a question about the Pro Series Top-Mount and is the answer not in the manual?
Questions and answers