Advertisement
TOOLS
REQUIRED
FOR ASSEMBLY
(!)
Pliers
(2)
7/16" Wrenches
(2)
1/2" Wrenches
(2)
9/16" Wrenches
REMOVAL
OF PARTS FROM CARTON
Remove all parts and hardware packages from the
carton. Lay out all parts and hardware and identify using
the illustrations on page 3.
STEP 1:
(SEE FIGURE 1)
1.
Turn the spreader upside down.
2.
Remove lock nut from middle bolt in crossover tube
and shaft support plate. Leave the bolt in place.
3.
Assemble hitch tube onto middle bolt and secure
it with the same lock nut you removed. DO NOT
TIGHTEN YET.
iMPORTANT:
The hitch tube must attach to the side of
the crossover tube opposite the shaft support plate.
STEP 2:
(SEE FIGURE 2)
4.
Assemble the two OUTER hitch braces to the hitch
tube using a 1/4" x 1-3/4" (B) hex bolt and a 1/4"
nylock hex nut (C). DO NOTTIGHTEN
YET. Do not
assemble the inner hitch braces at this time.
HITCH
(B) 1/4" x 1=3/4"
HEX BOLT
(C) 1/4" NYLOCK
HEX NUT
HITCH BRACE
OUTER
HITCH BRACE
OUTER
FIGURE 2
MIDDLE BOLT
HITCH
TUBE
SHAFT
SUPPORT
PLATE
CROSSOVER
TUBE
LOCK NUT
FIGURE 1
STEP 3:
(SEE FIGURE 3)
5.
Assemble a spacer (I), a 3/4" fiat washer (G), a wheel
(air valve facing out) and another 3/4" fiat washer (G)
onto the end of the axle that has only the small hole.
6.
install a 1/8" x 1-1/2" cotter pin (E) into the hole in the
axle.
SMALL HOLE
AIR VALVE
(E) 1/8" x 1-1/2"
COTTER PiN
(I) SPACER
(G) 3/4" FLAT
WASHER
FIGURE
3
4
Call 1-866-576-8388
for missing parts or assembly help
DO NOT RETURN TO STORE
Advertisement
