Using Bootpl32 - NEC 4650NX - SuperScript Color Laser Printer Network Manual

Using BOOTPL32

First follow these directions to set up TCP/IP in Windows
95/98, Windows NT 4.0, or Windows 2000:
Installing the TCP/IP Protocol
1. In Windows, open the Network control panel.
2. If TCP/IP Protocol is not installed, install it using the
following steps. (We are using Windows 95 in this
example.)
a. Select Configuration Tab in the Network control
panel and click Add button.
b. When Select Network Component Type dialog box is
displayed, select Protocol and click Add button.
14 SuperScript Color Laser Network Guide
c. When Select Network Protocol dialog box is
displayed, select Microsoft and TCP/IP and click OK
button.
d. Then, TCP/IP Protocol is installed.
e. Restart. The new protocol and service will not be
available until system is restarted.
Assigning the IP Address
Use BOOTPL32 to set the IP address and other TCP/IP
parameters manually. You can also use ARP/ping commands
if you prefer.
1. Insert the CD that came with your SuperScript printer.
2. Launch BOOTPL32
In Windows access the CD ROM drive and launch
BOOTPL32 from the bootp or utilities directory
or Type E:\BOOTP\BOOTPL32.EXE from the Start>Run
dialog box.
For 4650 Series printer use this path:
Type E:\Utilities\BOOTP\BOOTPL32.EXE from
the Start>Run dialog box.