Sharp PZ-50HV2U Service Manual page 17

1. How to Enter the Service Factory Mode
System standby state
Confirm that the plasma display and the AVC System turned on together and a
system cable is connected properly.
Service Factory Mode
Page 1/13
General information of the Plasma Display and AVC System
Page 2/13 to 9/13
Adjustment and setting item of the AVC System
Page 11/13 to 13/13
Adjustment and setting item of the Plasma Display
Note 1: When use the adjustment exclusive use remote control unit with a [AA5F] code.
: Be careful so that there is the case that page constitution is different.
Press the "
Perform the following operation by the remote control unit for less than 3 seconds.
• Press the "MENU" key
• Press the "ENTER" key
• Press the "0" key
Press the "Factory" key (Note 1)
Image receiving state
Press the "Factory" key (Note 1)
17
(POWER)" key (POWER OFF)
Switch a page
' "
with " " and " " keys.
PZ-50HV2, PZ-50HV2E
PZ-50HV2U