Table of Contents
Advertisement
Checking of intake temperature sensor
4) Turn on the ignition key. Start the engine and idling.
5) Measure the voltage of intake pressure sensor for ECU check.
Measuring the voltage of intake pressure sensor
- Measuring terminal:
- Measuring voltage: 0.1[V] ~ 4.9[V]
Remarks : Measuring unit of voltage : Voltage [V]
6) If the measured voltage is not normal,
Check the 'P' electric wire, 'P/G' electric wire, 'P /L' electric wire to see if they have been broken
or have short- circuited.
Replace the MAPAT sensor with new one and it rechecks.
If the measured voltage is normal,
Check the 'P' electric wire, 'P/G' electric wire, 'P/L' electric wire to see if they have been broken or have
short- circuited if there is a bad contact of terminal No. 3, No. 26, No.28 of ECU coupler.
If the electric wire is no problem, ECU is broken.
Replace ECU with the new one, it rechecks.
7) After fault repaired, To erase the memorized fault code in the ECU is refer to how to remove the fault code(5-10).
8.TPS(THROTTLE POSITION SENSOR)
It is Located on the right side of throttle body
CAUTION
!
Before disassembly, the key is off.
Remove
Lh.side cover
Air cleaner
TPS connector
TPS screw
Replace the TPS
ECU No.28(TBA)
~
ECU No.3(IMP GROUND)
EMS(Engine Management System)
5-17
Advertisement
Table of Contents
Need help?
Do you have a question about the S2-125 and is the answer not in the manual?
Questions and answers
Where on the bike is the cdi unit?
The provided context does not specify the exact location of the CDI unit on the DAELIM S2-125 motorcycle. However, in most motorcycles, the CDI unit is typically located under the seat or near the battery compartment. For precise location and installation details, refer to the DAELIM S2-125 service manual.
This answer is automatically generated