Table of Contents
Advertisement
IDLE SPEED
The engine must be at normal operating
temperature for accurate idle speed
adjustment. Ten minutes of stop-and-go
riding is sufficient.
1. Warm up the engine, shift to neutral
and place the motorcycle on its stand.
2. Adjust idle speed with the throttle stop
screw.
IDLE SPEED (IN NEUTRAL) :
1,600 100 min
CAUTION
Make sure that the engine is fully
warmed up before adjusting the idle
speed. Improper adjustment can
result in increased engine wear.
44
-1
(rpm)
SIDE STAND
Erect main stand and place motorcycle
in upright position on level ground.
Check the spring for damage or loss of
tension and the side stand assembly for
freedom of movement.
Check the side stand ignition cut-off
system;
Put the side stand up.
Start the engine.
Lower the side stand. The engine
should stop as you put the side stand
down.
If the side stand system does not
operate as described, inspect it in the
closest authorized repair center.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ROADWIN 125 FI and is the answer not in the manual?
Questions and answers
I lost the key of the motorcycle Daelim Roadwim of 2005and I want to change the petrol cap because I can't open it
The manual does not provide specific instructions for changing the petrol cap without a key. However, since the fuel fill cap requires the ignition key to open, you may need to contact a Daelim dealer for assistance or consider obtaining a replacement key using the key number plate provided with the motorcycle.
This answer is automatically generated