Advertisement
When all WDM sequences are disabled to 0 then you will be using 8 ASIO
channels.
Which driver you will need to use depends on your particular recording
program.
Additional mLAN Control Panel Notes
1.
Generally the only settings you will adjust will be drivers and buffer
settings.
2.
Always remember that anytime you change drivers or buffer settings,
you must hit the SET button. (
run the Patchbay, make your channel connections if necessary and hit APPLY.)
3.
If you cannot see the Revert-SET button you must change your
monitor viewing properties or auto-hide your taskbar.
4.
When you enable WDM sequences for the first time, you will get a
" Found New Hardware Wizard" to install the Yamaha mLAN Audio Ports.
The Yamaha mLAN Audio Ports are the WDM drivers.
This should appear 2 times. Click " Next" , " Continue Anyway" and then
" Finished" to proceed.
In doing so the Receive side will disconnect. Simply
Advertisement
