Configuring Lag Membership - Dell PowerConnect 2708 User Manual

Figure 6-6. VLAN Interface Settings
Interface — Indicates the interface number of the port, LAG, or VLAN that is configured on the
switch.
PVID (1-4095) — Assigns a VLAN ID to untagged packets. The possible field values are 1-4094.
VLAN 1 is used as the default VLAN. The default VLAN is only used as a port default VLAN ID
(PVID). VLAN 1 cannot be deleted from the system. VLAN 4095 is defined as the discard VLAN,
thus the packets classified to this VLAN are dropped. All ports must have a PVID defined; if no
other PVID value is configured, the default VLAN's VID will be used.
Frame Type — Packet type accepted by the LAG. The possible values are:
Admit Tag Only — Only tagged packets are accepted by the interface.
Admit All — Tagged and untagged packets are accepted by the interface.
Ingress Filtering — Enables or disables incoming filtering by the interface. Ingress filtering
discards packets which do not include an ingress port.
Updating the VLAN Interface Settings
Open the VLAN Interface Settings page.
1
Select the interface (port or LAG)
2
Click Apply Changes.
3
The switch VLAN Port Settings parameter(s) change(s) is applied.

Configuring LAG Membership

The switch supports six LAGs per system and four ports per LAG. When a port is added to a LAG,
it acquires the properties of the LAG.
52