Installing the Device
The following mounting instructions apply to all three hardware configurations of PowerConnect
2708, 2716, 2724 and 2748 devices. The section describes how to install a single device as a stand-
alone device.
Installing the Device in a Rack
CAUTION:
Disconnect all cables from the unit before mounting the device in a rack or cabinet.
CAUTION:
When mounting multiple devices into a rack, mount the devices from the bottom up.
To install the device in a rack, perform the following:
Place the supplied rack-mounting bracket on one side of the device ensuring the mounting
1
holes on the device line up to the mounting holes on the rack mounting bracket. The
following figure illustrates where to mount the brackets.
Figure 3-2. Bracket Installation for Rack Installation
Insert the supplied screws into the rack mounting holes and tighten with a screwdriver.
2
Repeat the process for the rack-mounting bracket on the other side of the device.
3
Insert the unit into the rack, ensuring that the rack-mounting holes on the device line up to
4
the mounting hole on the rack.
Secure the unit to the rack with the rack screws (not provided). Fasten the lower pair of screws
5
before the upper pair of screws. This ensures that the weight of the unit is evenly distributed
during installation. Ensure that the device ventilation holes are not obstructed.
29