Table of Contents
Advertisement
chrono graphs
adjusting the Chronograph Hands to Zero Position
. Pull out the crown to position . all three chronograph hands are in their
correct or incorrect zero position.
. Keep push-button A and B depressed simultaneously for at least 2
seconds. The center stop-second rotates 360º and corrective mode is
activated.
Adjusting the center stop second
single step: press push-button a 1 x short
continuous: press push-button a 1 x long
adjusting the Chronograph Hands to Zero Position
To adjust the next hand: press push-button B.
Adjusting the /0 sec counter hand (position h)
single step: press push-button a 1 x short
continuous: press push-button a 1 x long
To adjust the next hand: press push-button B.
Adjusting the minute counter hand (position h)
single step: press push-button a 1 x short
continuous: press push-button a 1 x long
. Push the crown back into position 0. Termination of the chronograph
adjustment can be carried out at any time.
chrono graphs
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the INVICTA and is the answer not in the manual?
Questions and answers
How do I adjust the watch band on the coalition forces Vulcan X
To adjust the watch band on the Invicta Coalition Forces Vulcan X, follow these steps:
1. Identify the direction of the arrows on the bracelet, which indicate the direction to push the pins.
2. Use the quick release band adjustment tool to push the pins in the direction of the arrows.
3. Once the pin is partially released, remove it completely with your fingers.
4. If needed, repeat the process to remove additional links.
5. To reassemble, insert the pin back in the opposite direction it was removed.
6. Use a mallet to gently tap the pin into place.
This method allows you to resize the watch band easily.
This answer is automatically generated