Sanyo HECSR1000K - Stiffness Sensor - Multi Roller Massage Chair Service Manual page 12

Operation Check of
Remote Controller and Sensor
1. With reclining "ERECT" and "RECLINE" on remote controller held depressed,
turn ON power supply switch.
2. Red LEDs (41 places) go on for 1 second (Fig. 1).
3. Green LEDs (25 places) go on for 1 second (Fig. 2).
4. Red LEDs at five places in the massage mode go on and operation of each sensor can be checked (Fig. 3).
Operation Check of Each Sensor
Body contour sensor
Speed "FAST" LED which is lighted goes out.
Perspiration sensor
LED "Put your finger on the sensor" which is lighted goes out.
Skin temperature sensor
When temperature is about 17
When temperature is over about 17
Pulse sensor
LED "Recovery from fatigue" blinks.
Red LEDs go on for 1 second (Fig. 1)
Red's lighting-up
Green LEDs go on for 1 second (Fig. 2)
Green's lighting-up
Press in the upper part of massaging arm.
When a finger is placed between two electrodes,
Attach a finger to sensor by the side.
(Fig. 3)
Body contour sensor
Skin temperature/Pulse sensor
Perspiration sensor electrodes
Red's lighting-up
Red's lighting-up
Red's lighting-up
Red's lighting-up
Green's lighting-up
Green's lighting-up
Green's lighting-up
Green's lighting-up
or lower,
,
Perspiration sensor
Skin temperature sensor
Red's lighting-up
- 12 -
HEC-DR21
Red's lighting-up
Presses
Green's lighting-up
LED "Ease" goes on.
LED "Ease" goes out.
Pulse sensor
(TAIWAN)