Ipod - Yamaha MCR-040 Owner's Manual

iPod™

Note
In case of a transmission error without a status message appearing in the front panel of this unit, check the connection to your iPod (see
page 5).
The following status messages appear only if you are using MCR-040.
Status message
iPod Connecting
iPod Charging
Unknown iPod
iPod
iPod Unplugged
The following status messages appear only if you are using MCR-140.
Status message
iPod Linked
iPod
iPod Unlinked
iPod Low Batt.
The following LED statuses of the status indicator refer to the transmitter.
LED status
Off
The transmitter is in standby mode.
An iPod is not connected or wireless
communication has not been established.
Flashes green Connection in progress.
Flashes green once
Adjusting the volume level or operating
with the remote control.
Lights up green Wireless communication between the
unit and transmitter is established.
Lights up green and An unsupported iPod is connected.
flashes red for 2
seconds
Lights up green and Connection failed.
keeps flashing red
Flashes red Error occurs.
Flashes red once The volume of the unit is set to maximum
or minimum.
Flashes red 2 times The battery of the iPod is low.
continuously
(regardless of green
status)
Cause
This unit is in the middle of recognizing
the connection with your iPod.
There is a problem with the signal path
from your iPod to this unit.
The iPod being used is not supported by
this unit.
This unit has recognized your iPod;
however, it cannot obtain information
such as elapsed time.
Your iPod was removed from the iPod
dock.
Cause
Wireless connection was successful.
Wireless connection has disconnected.
The battery of the iPod is getting flat.
Transmitter status
Remedy
If the message continues to appear in the front panel
display and playback does not start, connect the iPod
again.
Connect the iPod again.
Only iPod (5th generation), iPod classic, iPod nano,
and iPod touch are supported.
Station your iPod back in the iPod dock.
Remedy
Connect the iPod to the transmitter and start
playback.
Set it in the charging cradle.
Remedy
Please wait.
Only iPod (5th generation), iPod classic, iPod nano,
and iPod touch are supported.
Connect again.
Remove the iPod from the transmitter, and connect
again.
Set the iPod in the charging cradle.
TROUBLESHOOTING
Page
—
5
—
5
Page
5
5
Page
—
5
8
8
5
19
En