Advertisement
Available languages
Available languages
6
en | The Recovery Procedure
3.
4.
5.
6.
7.
8.
9.
10. Click the arrow, select Restart, and then click OK. This
11. Click Continue. The recovery procedure starts. A warning
F.01U.076.409 | V1 | 2007.11
Write down the network settings.
–
In the DiBos configuration, click the Security and
network menu, and then click Control panel. The
Network Connections window appears.
–
Double-click the Local Area Connection icon, click the
General tab, and then click Properties.
–
Double-click Internet Protocol (TCP/IP).
–
Click the General tab and write down all the settings
(e. g. IP address, subnet mask, standard gateway).
–
Click Cancel, click Cancel again, and then click Close.
Write down the computer name and the workgroup.
–
In the Network Connections window, click Control
Panel.
–
Double-click the System icon, and then click the
Computer Name tab.
–
Write down the full computer name and the
workgroup.
–
Click Cancel, and then close the Control Panel
window.
Exit the DiBos.
Exit Windows. To perform this, click Start, and then click
Log Off. The windows logoff dialog box appears.
Hold down the left SHIFT key, and then click Log Off. Hold
the left SHIFT key down until the Windows logon dialog
box appears.
Insert the Recovery DVD into the drive.
In the Windows logon dialog box, click Shut Down. The
Windows shut down dialog box appears.
action shuts down your computer and restarts the
computer with the Recovery DVD. The recovery window
appears.
message appears, stating that the recovery procedure will
delete all data on the hard disk (partition C:).
Installation Guide
DiBos 8 Recovery
Bosch Sicherheitssysteme GmbH
Advertisement
