Table of Contents
Advertisement
WD0046-04-08.qxd
21/7/08
WARNING
DISCONNECT POWER SUPPLY BEFORE OPENING
CAUTION
NEVER OPERATE THIS CLEANER WITHOUT THE CORRECT FILTER FITTED
Failure to do this will invalidate the guarantee. A clean filter is essential for this cleaner to operate
efficiently. If the filter becomes clogged or damaged or fails to operate you must fit an Earlex
replacement. Details are supplied with the cleaner. Dry Filter Part No WD0029, Foam Filter Part
No WD0030.
1
ARCHED VENTS
FOAM FILTER
3
PAPER BAG TO EXCEED
THE 10MM GAP
PAPER BAG TO EXCEED
THE 10MM GAP
10:54 am
Page 4
FILTER INSTALLATION
ARCHED VENTS
ARCHED VENTS
FOAM FILTER
FOAM FILTER
PAPER BAG TO EXCEED
THE 10MM GAP
2
WHEN FITTING FOAM FILTER
LEAVE AN APPROX 10MM GAP,
ENSURING ALL ARCHED VENTS
ARE COVERED
PAPER FILTER
HOUSING
HOUSING
ELASTIC BAND FITTED
OVER THE PAPER FILTER
IN THE GAP BETWEEN
THE HOUSING AND THE
FOAM FILTER
ELASTIC BAND FITTED
ELASTIC BAND FITTED
OVER THE PAPER FILTER
OVER THE PAPER FILTER
IN THE GAP BETWEEN
IN THE GAP BETWEEN
THE HOUSING AND THE
THE HOUSING AND THE
FOAM FILTER
FOAM FILTER
PAPER FILTER
PAPER FILTER
PAPER FILTER
4
WHEN FITTING FOAM FILTER
WHEN FITTING FOAM FILTER
LEAVE AN APPROX 10MM GAP,
LEAVE AN APPROX 10MM GAP,
ENSURING ALL ARCHED VENTS
ENSURING ALL ARCHED VENTS
FOAM FILTER
ARE COVERED
ARE COVERED
FOAM FILTER
FOAM FILTER
PAPER FILTER
PAPER FILTER
IF THE BAG AND OR THE FOAM F
PERFORATED DO NOT OPERATE
HOUSING
IF THE BAG AND OR THE
REPLACEMENT PARTS ARE AV
FOAM FILTER ARE
THROUGH OUR CUSTOMER S
PERFORATED DO NOT
OPERATE THE UNIT.
REPLACEMENT PARTS ARE
AVAILABLE THROUGH OUR
CUSTOMER SERVICE
OFFICE ON 01483 454666
IF THE BAG AND O
IF THE B
OFFICE ON 01483 4546
PERFORATED DO N
PERFOR
REPLACEMENT P
REPLA
THROUGH OUR
THRO
OFFICE O
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the COMBIVAC and is the answer not in the manual?
Questions and answers
How do I change the filter
To change the filter on the Earlex COMBIVAC:
1. For Dry Pick-Up:
- Ensure the foam filter is dry.
- Slide the foam filter down over the float cage until it touches the top.
- Carefully install the paper filter over the foam filter.
- Secure the paper filter with the rubber band, ensuring it fully covers the foam filter up to the shoulder of the molding.
- Periodically brush dirt off the paper filter with a soft brush.
2. For Wet Pick-Up:
- Remove the paper filter (do not use it for wet pick-up).
- Use only the foam filter.
- Clean the foam filter with soapy water when necessary and dry it thoroughly before using it again.
3. Maintenance:
- Periodically replace the paper filter.
- Wash the foam filter with soapy water, rinse, and dry before reinstalling.
- Ensure the filters are clean and undamaged for proper operation.
This answer is automatically generated
How to get it into suction mode
To switch the Earlex COMBIVAC to suction mode:
1. Ensure the motor housing is clipped onto the base correctly, with the air outlet opposite the vacuum inlet hose.
2. Assemble the hose by connecting it to the recovery tank, making sure it is properly secured.
3. Attach an extension tube and either the floor head or crevice tool if needed.
4. Unwind the mains lead fully and plug it into a power source.
5. Switch the unit on to begin suction operation.
This answer is automatically generated