EDGE BLENDING
(Not available for PT-D5000)
The built-in edge blending feature allows multiple projector
images to be seamlessly overlapped by adding a brightness
ramp. Press F G to select the required option.
OFF
Deactive
Adds a brightness ramp to the
ON
overlapped area and adjustable the
overlapping position manually.
Adjusting EDGE BLENDING
1. Select ON and press the ENTER button to display the
detailed options.
2. Switch between ON/OFF of the required connecting
edge.
3. Press I H to adjust the value of START and WIDTH.
WIDTH of the both projectors must be the same value.
Vertical connecting
Projector 1
LOWER: ON
Overlapped
Projector 2
UPPER: ON
Horizontal connecting
Overlapped
Projector 1
RIGHT: ON
Projector 2
LEFT: ON
Adjusting with colour markers
You can adjust with colour markers, which indicate the
overlapping area.
1. Press G several times until MARKER is displayed.
2. Select MARKER and press I H to switch between ON/
OFF.
Green and red lines will be displayed.
Green line indicates START point, and red line indicates
WIDTH from START point.
Adjust START and WIDTH for superimposing the green line
to the red.
Overlapping area
Projector 1
Green lines
Red lines
Selecting gamma level
You can adjust gamma level of the lapping area for fine
adjustment.
1. Select GAMMA and press the ENTER button.
2. Press I H to cycle through the options.
Options are 2.2, 1.8 and 2.0.
3. Press the ENTER button to apply the setting.
ADVANCED MENU
Projector 2
E
NGLISH - 23