How To Set Up And Attach The Accu-Rip To Your Saw - Craftsman 25980 - Accu-Rip Saw Guide User Instructions

ALWAYS DISCONNECT THE POWER SOURCE BEFORE ATTACHING THE ACCU-RIP TO YOUR SAW.
NOTE: The Accu-Rip is fully assembled. The various
screws and bolts should not be removed. You should
only loosen and retighten these parts as you setup,
attach, and remove the Accu-Rip.

HOW TO SET UP AND ATTACH THE ACCU-RIP TO YOUR SAW

1
7
Loosen the Cut-Guide handle (D), and slide the Cut
Guide (E) to the 24" end of the scale, and retighten
the handle (Fig.1). This will hold the guide out of
the way during the setup.
(B) Retainer
Screw
(C) L-Brackets
3
7
Loosen the Retainer Screws (B) just enough to
allow the L-Brackets (C) to move freely (Fig 3).
Do not remove the Retainer Screws
completely.
Make sure your saw is unplugged from the power source!
(D) Cut-Guide Handle
(E) Cut-Guide
Fig. 1
(B) Retainer
Screw
Fig. 3
IMPORTANT!
The Accu-Rip is designed to allow you to adjust the
tool to fit most circular saws with blades on the RIGHT
SIDE. Some circular saws, particularly older saws, may
have designs that prevent the use of the Accu-Rip with
that saw.
(A) T-Bolts
2
7
Loosen the T-bolts (A) so that there is roughly 1/2
inch clearance between the Accu-Rip base and the
points of the T- Bolts (Fig. 2) Do not remove the
T-bolts completely.
4
7
Raise the saw blade guard. Position saw on a
securely held in place flat surface, such as a
worktable, so that the blade is firmly against the
surface straight edge.
½"
Fig. 2
Blade should be
against edge
Fig. 4
2