Removing And Replacing The Power Supply; Removing The Power Supply - HP A5585A - SureStore DLT E Tape Library 4/40 Upgrade And Replacement Instructions

Removing and Replacing the Power Supply

A failing power supply on Model 2/20 disables the library. A failing
power supply on upper library levels results in a partial availability
state. When the library is in a partial availability state, it is still
functional, but is not in optimum configuration. When this occurs, the
front panel will display
beneath the front panel display will be solid amber until the condition is
resolved. (Refer to your user's guide for more information on the partial
availability state.)

Removing the Power Supply

1. Power off the library.
2. Disconnect the power cord from the back of the power supply.
3. Loosen the thumbscrews at the top and bottom of the power supply. If
4. Remove the stop bracket (for Model 2/20 only).
Figure 2-31 Removing the Stop Bracket for Model 2/20
Chapter 2
Level of Difficulty: [1] Easy
Partially Available
the thumbscrews are too tight to loosen by hand, loosen them with a
screwdriver.
Removing and Replacing Major Library Components
Removing and Replacing the Power Supply
, and the illuminated LED
2-59