Mountfield 1538M SD Instruction Manual page 32

PROBLEM
5. The motor shuts down whilst working
6. The blades do not engage
7. Uneven cut
8. Unusual vibrations while working
9. With the engine running, the machine does
not move when the drive pedal is pressed
( for hydrostatic drive models)
If problems continue after having carried out these operations, contact your dealer.
WARNING!
Do not take on complicated repair work if you don't have the necessary equipment or the techni
knowledge. The warranty is automatically voided and the manufacturer is not held responsible if repairs are done
badly.
EN 32
LIKELY CAUSE
– the safety devices have cut in
– fuse blown (10 A)
– problems with engagement mechanism
– cutting deck not parallel to the ground
– blade cuts badly
– cutting deck is full of grass
– blades are unbalanced or loose
– bolts and screws are loose
– move the disengagement lever to position
«B»
SOLUTION
– check that the conditions allowing starting
are met ( 5.2.b)
– replace the fuse (10 A) ( 6.3.5)
– contact Your Dealer
– check pressure and the external diameter of
the tyres ( 6.3.1) or contact your Dealer
– contact Your Dealer
– clean the cutting deck ( 5.4.8)
– contact Your Dealer
– check and tighten all the engine and frame
bolts
– move it to position «A» ( 4.33)
cal