Pioneer AVIC N1 - Navigation System With DVD player Operation Manual page 110

Message
Direction of G sensor is not correct.
Please power off the system and
check the installation. After you have
checked, please re-boot the system
and press "OK".
Sensor NG (BAD) angle
Gyro Sensor is not working properly.
Please consult your dealer or Pioneer
service center.
The route could not avoid the speci-
fied area.
Your route could not be found.
Route calculation was not possible.
Route calculation was not possible
because the destination is too far.
Route calculation was not possible
because the destination is too near.
Route calculation was not possible
due to traffic regulations.
Route calculation was not possible
because no guidance can be pro-
vided around the destination or the
starting point.
There is no route to the destination.
The maximum number of registra-
tions has been completed. Please
clear existing registered items and
re-register current item.
Memory is full.
Irregular character strings. Please
input again.
An error has occurred. Please note
the following error code and switch
power off.
108
When
Direction of G sensor is set incor-
rectly.
The navigation unit is installed with
an extreme angle exceeding the limi-
tation of the installation angle.
Abnormal output of Gyrosensor is
detected.
If route setting cannot avoid speci-
fied Areas to Avoid.
Route calculation has failed because
of malfunction of map data, software,
hardware, or disc.
Route calculation has failed because
of malfunction of map data, software,
hardware, or disc.
The destination is too far.
The destination or way point(s) is too
close.
•The destination or way point(s) are
in a Control Traffic Zone (CTR) and
the route calculation is hampered.
•Your vehicle is currently in a Control
Traffic Zone (CTR) and the route cal-
culation is hampered.
The destination, way point(s), or
starting point are in an area where
no road exists (e.g. a mountain) and
the route calculation is impossible.
The destination or way point(s) are in
an isolated island, etc. without a ferry
and the route calculation is impossi-
ble.
If there are already 300 items when
you attempt to register an item in the
Address Book.
When the total 300 resistered points
are in the CD-R and Address Book,
you attempt moving an item to the
Address Book from CD-R.
A symbol that cannot be pronounced
was entered.
In the case of a system failure.
What to do
See the "Installation Manual" and set
the direction of the Hide-away unit
correctly.
Confirm the installation angle. (The
navigation system must be installed
within +30 degrees to –30 degrees of
the horizontal, or within five degrees
of your vehicle's direction of travel.)
Note down the error code shown on
the screen; turn off the power, and
then contact your nearest Pioneer
service facility.
Choose whether or not to try setting
a route through the area.
•Change the destination.
•Clean the disc.
•Consult the Pioneer Local dealer if
this message persists.
•Change the destination.
•Clean the disc.
•Consult the Pioneer Local dealer if
this message persists.
• Set a destination closer to the start-
ing point.
• Set one or more way points.
Set a destination [and way point(s)]
farther from the starting point.
•Set a destination and way point(s)
outside the CTR if you know where
the restricted area is.
•Try the destination or way point(s)
away from the currently set points to
some extent.
•Drive your vehicle to an unre-
stricted area and reset the destina-
tion and way point(s).
•Set a destination and way point(s)
on roads.
•Reset the destination after you drive
the vehicle to any road.
Change the destination.
Delete some destinations as appro-
priate.
Delete unnecessary data and try to
register again.
Enter a word that can be pro-
nounced.
Note down the error code shown on
the screen; turn off the power, and
then contact your nearest Pioneer
service facility.