Problems In The Audio Screen (Common) - Pioneer AVIC N1 - Navigation System With DVD player Operation Manual

Symptom
The map continually reorients itself.
Tracking marks are not displayed.
The daylight display is used even
when the vehicle lights are on.
The system will not switch on or will
not operate.
The display is very dim.
There is no voice guidance or the vol-
ume is low.
Does not switch to Vehicle Dynam-
ics.
Slope is not displayed on the
Vehicle Dynamics screen.
Inclination does not move on the
3D Calibration screen.
When the screen is frozen...
Park your vehicle at a safe place, and cut the engine off. Turn the ignition key back to "Acc off". Then
start the engine again, and turn the power to the navigation unit back on. If this does not solve the
problem, press the RESET button on the navigation unit.

Problems in the Audio screen (common)

Cause
Your vehicle is operating in Simple
hybrid mode.
The navigation unit is installed with
an extreme angle exceeding the limi-
tation of the installation angle.
Indication of the position of your
vehicle is misaligned after a U-turn or
reversing.
The traveling direction is always set
to north.
The "Tracking Display" is turned
off.
Daytime is selected on "Day/Night
Display".
The Orange/white lead is not con-
nected.
Installation or connection has been
carried out incorrectly.
The vehicle's light is turned ON, and
"Nighttime" is selected on "Day/
Night Display".
The vehicle cabin temperature is
extremely low.
Picture quality adjustment of the dis-
play is not correct.
Ambient light sensor of the display is
hidden.
The volume setting is low or the
speaker lead is disconnected.
The navigation unit sensor does not
begin working immediately after the
navigation unit is installed on the
vehicle.
The speed pulse lead is not con-
nected.
Action (See)
Connect the speed signal input (pink
lead wire) of the power cable cor-
rectly, and reset the 3D Hybrid Sen-
sor ("Learning Status").
Confirm the installation angle. (This
unit must be installed within +30
degrees to –30 degrees of the hori-
zontal, or within five degrees of your
vehicle's direction of travel.)
Check whether or not the reverse
gear signal input lead (purple) is con-
nected properly. (The Navigation Sys-
tem works properly without the lead
connected, but positioning accuracy
will be adversely affected.)
Touch on the screen and change
the map display.
Check the "Tracking Display" set-
➞
tings ( Page 56) and make sure
"Always" or "This Trip" is selected.
Check the "Day/Night Display" set-
➞
ting ( Page 56) and make sure
"Nighttime" is selected.
Check the connection.
Check with your dealer.
Read about the "Day/Night Dis-
➞
play" setting ( Page 56) and, if
desired, select "Daytime".
A Liquid Crystal Display (LCD) is
used, and such displays tend to
darken when cold. Wait for the vehi-
cle to warm up.
Refer to "Hardware Manual" to
adjust the picture quality.
Set the ambient light sensor not to
be hidden.
Check the volume setting on the dis-
play or turn the volume up according
➞
to "Hardware Volume" (
and/or turn up the volume on the dis-
play.
Drive for a little while.
Connect the speed pulse lead.
Page 56)
105