The following table summarizes the equivalent CLI commands for configuring ports as
displayed in the Port Configuration.
CLI Command
interface ethernet interface
description string
shutdown
set interface active {ethernet
interface | port-channel port-
channel-number}
speed {10 | 100 | 1000}
duplex {half | full}
negotiation
back-pressure
flowcontrol {auto | on | off | rx |
tx}
mdix {on | auto}
show interfaces configuration
[ethernet interface | port-
channel port-channel-
number]
show interfaces status [ethernet
interface | port-channel port-
channel-number]
214
Configuring Switch Infor m ation
Description
Enters the interface configuration
mode to configure an ethernet type
interface.
Adds a description to an interface
configuration.
Disables interfaces that are part of
the currently set context.
Reactivates an interface that is shut
down due to security reasons.
Configures the speed of a given
ethernet interface when not using
auto negotiation.
Configures the full/half duplex
operation of a given ethernet
interface when not using auto
negotiation.
Enables auto negotiation operation
for the speed and duplex parameters
of a given interface.
Enables Back Pressure on a given
interface.
Configures the Flow Control on a
given interface.
Enables automatic crossover on a
given interface or Port-channel.
Displays the configuration for all
configured interfaces.
Displays the status for all configured
interfaces.