Midland X-TALKER T295VP4 Manual page 5

Model T290 Series
BATTERY INSTALLATION
Your radio operates with a rechargeable NiMH battery pack
(BATT5RX). The belt clip should be removed (see below) to ease
installation or removal of the battery pack.
To install the battery pack:
1. With the back of the radio facing you, remove the belt clip (see
diagram below) for easy access, then remove the Battery Cover
by pulling down the Battery Cover Lock Tab and lifting up the
Battery Cover from the radio.
2. Insert the battery pack observing the polarity as shown. Installing
the batteries incorrectly will prevent the radio from operating or
may damage the radio.
3. Return the Battery Cover by sliding it down on the radio and push
down the Battery Cover Lock Tab until it locks into place. Replace
the belt clip, making sure it locks into place.
BATT5RX NiMH
RECHARGEABLE
BATTERY PACK
INSTALLING THE BELT CLIP
To install the BELT CLIP, slide the clip down
into the slot on the back of the radio until the
BELT CLIP LATCH clicks. To remove the
BELT CLIP, pull the LOCK TAB away from
the radio, then gently pull the belt clip up
toward the top of the radio.
Page 5
BATTERY COVER
LOCK TAB
BELT CLIP
LOCK TAB
BELT CLIP
LATCH
midlandusa.com