Growatt MIN 8200TL-XH-US Installation & Operation Manual page 24

7.3.2 LED description
The single LED indicates the operational status of inverter.
LED Designation Color Status
Green ON
Green Blink
POWER Green Blink
Green Blink
Green Blink
Green ON
Green Blink
Green Blink
COMM
Green Blink
Green Blink
Blank ON
Green ON
Green Blink
BAT Green Blink
Green Blink
Blank ON
Red ON
FAULT Red Blink
Red ON
The LED combination indicate the operational status of inverter.
LED Designation Color Status
POWER Green ON
BAT Green ON
COMM Green ON
FAULT Red ON
POWER Green Blink
BAT Green Blink
COMM Green Blink
FAULT Red Blink
POWER Green Blink
BAT Green ON
BAT Green Blink
COMM Green Blink
41
Action Message
steady Feed in grid
3s on/1s off DC ON/AC OFF
1s on/3s off DC OFF/AC ON
0.5s on/0.5s off synchronizing with grid
2s on/2s off standby mode
steady BAT is in normal operation
1s on/3s off BAT is in low power
0.5s on/0.5s off BAT is in fault mode
1s on/1s off BAT interal comm. Fail
2s on/2s off BAT is in standby mode
steady No BAT , PV inverter mode
steady 4G/WiFi,local WiFi ok
0.5s on/0.5s off Local WiFi connecting
1s on/1s off WiFi/ 4G fail,Local WiFi ok
1s on/3s off Local WiFi fail,4G/WiFi ok
steady Comm. Fail
steady Arc Fault(with the buzzer on)
1s on/1s off Warning
steady Fault
Action Message
In sequence DSP Firmware Update
1s on/1s off M3 Firmware Update
3s on/1s off
Backup mode
steady
1s on/1s off BAT internal comm. Fai
7.4 Powering off the system
Ø
After the inverter powers off, the remaining electricity and heat may
still cause electric shock and burns. After power-off, wait 5 minutes
before servicing the inverter. Always wear protective gloves when
servicing the inverter.
Ø
If the inverter is connected to the battery, ensure that a shutdown
command is sent from the APP. Power off the system after the inverter has
WARNING
shut down. If no shutdown command is sent from the app, the inverter
will shut down after the power grid is off, the inverter will wait for
meanwhile, then charge the battery by solar power and the inverter enter
off grid mode.
Ø
Power off both Grid, PV and Battery totally, can shut down the system.
Ø
Send a shutdown command from the APP. for details, see the Operations on the
Shinephone APP.
Ø
Turn off the AC switch between the inverter and the power grid.
Ø
Turn off the DC switch at the bottom of the inverter.
Ø
If a battery connects to the battery port of the inverter, power off the battery.
Ø
The system is shutdown.
7.5 Button
7.5.1 Reset button
There is a button located inside the wiring box. for this button,there are the The
ffollowing functions are for reset botton:
Button Application
Arc reset Clear arc fault
If there is no arc fault, run arc
Arc self-test
self-test
Gateway reset to factory
Gateway reset
status
Fig 7.2
Trigger condition
Press the button for 3-5 seconds
Press the button for 3-5 seconds
Press the button for more than 10
seconds
42