NEC VERSA DOCK Manual page 84

Try moving the speakers away from the NEC Versa Dock.
Try adjusting the volume with the volume control knob. If that
doesn't work, open the Speaker Control Dialog Box in Windows
and adjust the volume control with the slide bar. You can also try
adjusting the Mic control in the Mixer.
!
When docked, there is no sound from attached external speakers.
Check to see that the external speakers are connected properly to
the NEC Versa Dock and are powered on.
Check to see that the Dock Settings tab in the Device Manager is
properly set. See "External Audio Options" in Chapter 4 for
instructions.
!
When docked, the NEC Versa does not work as it did when docked
previously and the settings seem to have changed.
Reboot your system, go into the NEC Versa Setup utility, and
reset the parameters.
The battery in the NEC Versa Dock may need to be replaced. See
"Replacing the Battery" in this chapter for instructions.
!
The floppy disk drive in the optional VersaBay III Adapter Kit is not
detected when the NEC Versa is powered on.
In the BIOS setup, configure and enable diskette B.
!
Motorized dock or undock is not functioning.
Ensure that the keylock is in the full upright position (Normal).
With the key midway between Manual and Normal, motorized
function is disabled.
!
Drive designations do not appear after starting system using a dual
boot configuration.
Reboot the system twice.
Solving Problems 5-3