Installing Cards
Connecting the T1/E1/PRI Card
To install the T1/E1/PRI Card:
1.
Turn to System Preparation (page 21) to be sure you haven't exceeded the allowable system load factor.
Set jumpers CN7 and CN9 to the T1 position.
2.
- CN7 and CN9 are not required for T1 installations. You can optionally leave them off.
Plug in T1/E1/PRI Trunk Cards as required.
3.
4.
Set the mode switch on each T1/E1/PRI Card to RUN .
5.
Using a standard straight-through CAT 5 cable, connect the T1/E1/PRI Card RJ48C connector to your CSU.
38 ◆ Installation
Figure 20: Connecting the T1/E1/PRI Card
DSX-80 4-Slot KSU Shown
DSX-80/160 Hardware Manual