Cisco Meraki MR86 Installation Manual page 5

LED indicator
Your MR86 is equipped with a multi-color LED light on the bottom edge of the unit to convey information about system functionality and performance:
• Orange - AP is booting (permanent Orange suggests hardware issue)
• Rainbow - AP is initializing/scanning
• Blinking Blue - AP is upgrading
• Green - AP in Gateway mode with no clients
• Blue - AP in Gateway mode with clients
• Blinking Orange - AP can't find uplink
The MR86 may be operated in "Run Dark" mode for additional security and to reduce the visibility of the access point. In this mode, the LED will not be
illuminated. This mode may be enabled through the Meraki dashboard.
Ethernet Port
The MR86 features one Ethernet ports:
This port accepts 802.3at power and should be used as the primary uplink to your LAN/WAN.
N-Type antenna attachment ports (4x)
2x N-Type antenna ports are located at the top of the MR86 and 2x are located at the bottom of the MR86. The 4 antenna ports are connected to both 2.4 GHz
and 5 GHz client serving radios. In order to ensure the highest performance, ensure antennas connected to the 4 ports have overlapping coverage areas.
Mount plate attachment slots
The mounting slots located on the rear shell of the MR86 marry to the 4 mounting posts on the mounting plate, securely fastening the MR86 to the mounting
plate.
Factory reset button
The factory reset button is located in a small pin-sized hole just above the PoE Ethernet port of the MR86. If the button is pressed and held for at least five
seconds and then released, the MR86 will reboot and be restored to its original factory settings by deleting all configuration information stored on the unit.
The Vent
The vent allows pressure equalization between the interior and the environment. This prevents internal condensation and maintains a waterproof seal.
5