Cleaning And Replacement Of Air Filter - Panasonic PT-D10000 Operating Instructions Manual

Cleaning and replacement of air filter

If the air filter is blocked with too much dust, the inside of the projector will become hot and the temperature monitor
(TEMP) indicator will flash and the power will turn off. The static electric mesh filter should be replaced and the
metal mesh filter and brush inside the filter unit should be cleaned after approximately 2 000 hours of use, although
this is a guide only and the actual time will vary depending on the operating conditions.
Procedure of cleaning
1. Turn off the main power and remove the power plug from the receptacle. 1. Turn off the main power and remove the power plug from the receptacle.
• • Turn off the main power supply observing the procedure (How to turn "OFF" the power supply) on page 36 Turn off the main power supply observing the procedure (How to turn "OFF" the power supply) on page 36
and then remove the power plug. and then remove the power plug.
2. Use a Phillips screwdriver to 2. Use a Phillips screwdriver to
loosen the filter cleaning unit loosen the filter cleaning unit
fixing screw at the front of the fixing screw at the front of the
projector. projector.
• • Insert your hand into the base of the air filter Insert your hand into the base of the air filter
and pull the air filter forwards while removing the and pull the air filter forwards while removing the
filter cleaning unit from the projector. filter cleaning unit from the projector.
3. Remove the static electric mesh 3. Remove the static electric mesh
filter from the filter cleaning unit. filter from the filter cleaning unit.
• • Loosen the static electric mesh filter so that it Loosen the static electric mesh filter so that it
can be removed, and then remove it. can be removed, and then remove it.
4. Place the filter cleaning unit 4. Place the filter cleaning unit
upside down. upside down.
5. Remove the four brush cover 5. Remove the four brush cover
fixing screws, and then remove fixing screws, and then remove
the brush cover and the movable the brush cover and the movable
metal mesh filter from the filter metal mesh filter from the filter
cleaning unit. cleaning unit.
6. Clean the filter cleaning unit, 6. Clean the filter cleaning unit,
brush and movable metal mesh brush and movable metal mesh
filter. filter.
• • Use a vacuum cleaner to remove any dust Use a vacuum cleaner to remove any dust
blockages. blockages.
108
– ENGLISH
Filter cleaning Filter cleaning
unit unit
Filter cleaning unit fixing screw Filter cleaning unit fixing screw
Brush cover fixing screws (4 places) Brush cover fixing screws (4 places)
Brush cover Brush cover Movable metal mesh filter Movable metal mesh filter
Movable metal mesh Movable metal mesh
filter filter
Brush cover Brush cover
Brush Brush
Static electric mesh filter Static electric mesh filter
Brush Brush Filter cleaning Filter cleaning
unit unit