Konica Minolta bizhub C360i Service Manual page 238
Hide thumbs
Also See for bizhub C360i:
- Quick manual (94 pages) ,
- Manual (42 pages) ,
- Quick reference (4 pages)
Advertisement
bizhub C360i/C300i/C250i
[1]
[3]
[3]
[1]
[2]
[4]
OK
NG
7. To reinstall, reverse the order of removal.
NOTE
▪ Be careful not to pinch the harness.
6.15 Stamp (SP-501)
[1]
[1]
[3]
2. Lift up the guide plate DF1 [1].
3. Remove the screw [2], and remove the cover [3].
NOTE
[2]
4. Remove the screw [1], and remove the ground terminal [2].
5. Disconnect the connector [3].
6. Remove the stamp unit [4].
NOTE
1. Open the left cover [1].
2. Lift up the guide plate DF1 [1].
3. Remove the screw [2], and remove the cover [3].
[2]
F DISASSEMBLY/REASSEMBLY > 6. DF-632/SP-501
▪ Remove the guide plate while shifting it to the right when viewed
from the back side of the main body.
▪ Ensure that the ground terminal is on the upper side of the mounting
bracket of stamp unit.
▪ Route the harness as shown in the illustration to place its connector
under the guide plate.
F-85
Advertisement
Troubleshooting
Need help?
Do you have a question about the bizhub C360i and is the answer not in the manual?
Questions and answers
How to open ADF and replaced roller
To replace the roller on the ADF of a Konica Minolta bizhub C360i:
1. Open the ADF (Document Feeder) by removing the rear cover.
2. Lift up the document feed tray.
3. Remove the lever for document exit.
4. Remove six screws and take off the cover.
5. Remove two screws securing the roller.
6. Replace the document pick-up roller, document feed roller, and document separation roller at the same time.
7. After replacing, reset the “ADF Feed” counter in Service Mode: [Service Mode] -> [Counter] -> [Life] -> [ADF Feed].
Note: These rollers do not have a new article detection mechanism, so manual counter reset is required.
This answer is automatically generated