Commissioning The User Terminal Using The Hughes Leo App; Start Install Without Logging In - EchoStar HUGHES OneWeb HL1120W UT Installation Manual

After power on, the user terminal should automatically commission itself. If you are not able to access
the internet through the user terminal within 5 minutes, then follow the manual commissioning
procedure as given in the following sections.
Note: If it has been more than 3 months or so since the UT was tested at a Hughes factory, self-
commissioning may not succeed as an up to date OneWeb satellite ephemeris file is needed.
The manual commissioning procedure will allow you to update the UTs ephemeris file and for
the satellite modem to work normally.

Commissioning the user terminal using the Hughes LEO app

Follow the steps below to commission the user terminal using the Hughes LEO app.
Start install w ithout logging in
Note: Currently, authentication with HL1120W user terminal is disabled by default.
Follow the steps below to connect the Hughes LEO app with HL1120W user terminal.
1. Connect the smartphone to the IDU via Wi-Fi (refer to
connection to the HL1120W-IDU
2. Launch the app on the smartphone (see
phone on page 77.)
3. Once the landing screen is displayed, click Start Install, as shown in
Avoid moving out of the IDU's Wi-Fi range during the commissioning process.
Disconnecting from the IDU Wi-Fi could disrupt the commissioning process.
90
Chapter 6 • Using user terminal Hughes LEO app
1043630-0001 Revision C
WorldVu Development LLC and Hughes Network Systems LLC Proprietary.
Using your smart device to establish a
on page 73).
Launching user terminal Hughes LEO app on a smart
Figure 86.