Load Nuc Options - FLIR RS8500 Series User Manual

6 – Interfaces

5.5.5 Load NUC Options

Typically, all of the camera configuration parameters are derived from the current Camera State.
When the camera is powered up, it loads the last saved camera state. The names of the NUCs are
stored as part of the state. Normally the NUC is performed with the settings that are eventually going
to be part of the state. If a NUC is loaded that has a setting that differs from the camera state, the
state will override the NUC. If the user wants the NUC setting to override the state, then "Load NUC
Options" can be set.
The default setting is to "Load Table Only", in which case only the NUC coefficients are used from a
NUC file. When the user selects "Load Table and the Following Settings", the user can select which
parameters from the NUC will override the current state. The option will not affect NUCs that are
currently loaded into RAM, only those NUCs that are subsequently loaded from Flash memory.
Unless a new state is saved, these override settings will not be remembered after a power cycle.
RS8500 User's Manual
56