Media Sensor Adjustment - Datamax W-6208 Operator's Manual

3.2 Media Sensor Adjustment

The Media Sensor needs to be positioned so that the printer can detect the
presence of media and the top-of-form (except for continuous stock, where the
TOF is set through programming; see Label Length, Section 4.1.2). To adjust:
With media loaded, as described in Section 3.1.1 or 3.1.2, turn the Media
Sensor Adjust Knob clockwise (outward) or counterclockwise (inward)
until the Sensor Eye Mark is positioned over the media according to the
table below.
If loading media, return to the media loading instructions.
Media Type
Die-cut
Notched
Reflective
Continuous
*
See Section 4.1.2 for Sensor Type selection.
Note: Changes to the start of print position can be made using the Print
Control / Row Adjust or Row Offset (see Section 4.1.3).
W-Class
Media Sensor Selection and Adjustment
Sensor Eye Mark Position
Near the middle of the label
Centered over the notch
Centered over the black mark
Near the middle of the media
Sensor Required
Gap
Gap
Reflective
Continuous
15
*