Specifications For 4G; Fcc Statement - TRANSTEK TeleCuff Gen 1 User Manual

SPECIFICATIONS FOR 4G

Specifications for 4G
Supporting
Cat-M1:
band：
B2/4/12
1850—1910MHz,
Transmitted
1710—1755MHz,
frequency range
699—716MHz
Transmitted power 20±2dBm
E-MTC
Throughput 588~1119 kbps
Latency
≤21ms
Jitter
≤21ms
PER
＜10%
Data shall be transmitted correctly and
Data Integrity
completely
Accessibility Accessibility is high since 4G is broadband
Remark:
1.The Quality of Service (QoS) is considered as KPIs here.
2. For the Blood Pressure Monitor，the E-MTC is used to transmit the control data
between the EUT and the controller,the manufacture considered 375~1119 kbps is a
suitable throughput for the usage
3.The PER of the wireless system is normally less than 1%, for Semi-anechoic chamber,
we considered the PER cannot be greater than 10%.
4. Use the wireless module which the EUT used as the test model,instead the EUT.
Warning
Failure to comply with the following warnings may cause cybersecurity issues.
casually use the blood pressure monitor for others, as it may lead to leakage of
DO NOT
personal measurement data.
connect the blood pressure at places with poor network or wireless connectivity.
DO NOT
as it may interrupt data upload and lead to deficient data.
5 27

FCC STATEMENT

FCC ID: OU9LS802GAM2
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
Caution：The user is cautioned that changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit di erent from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
FCC Responsible Party
Name: MIO LABS INC.
Address: KCH, 575 Lexington Ave 14F New York, NY 10022
Telephone: 301-910-0529
E-mail: mio@transtekcorp.com
5 28