Restoring Factory Settings In Computer Setup - HP L3C64AV Maintenance And Service Manual

To exit Computer Setup menus, choose one of the following methods:
To exit Computer Setup menus without saving your changes:
●
Select the Exit icon in the lower-right corner of the screen, and then follow the on-screen instructions.
– or –
Select Main, select Ignore Changes and Exit, and then press enter.
To save your changes and exit Computer Setup menus:
●
Select the Save icon in the lower-right corner of the screen, and then follow the on-screen instructions.
– or –
Select Main, select Save Changes and Exit, and then press enter.
Your changes go into effect when the computer restarts.

Restoring factory settings in Computer Setup

NOTE: Restoring defaults will not change the hard drive mode.
To return all settings in Computer Setup to the values that were set at the factory, follow these steps:
1. Start Computer Setup. See
2. Select Main, and then select Apply Factory Defaults and Exit.
NOTE:
Defaults and Exit.
3. Follow the on-screen instructions.
4. To save your changes and exit, select the Save icon in the lower-right corner of the screen, and then
follow the on-screen instructions.
– or –
Select Main, select Save Changes and Exit, and then press enter.
Your changes go into effect when the computer restarts.
NOTE: Your password settings and security settings are not changed when you restore the factory settings.
Starting Computer Setup on page
On select products, the selections may display Restore Defaults instead of Apply Factory
162.
Using Computer Setup 163