Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for XHDATA D808
Summary of Contents for XHDATA D808
- Page 1 XHDATA D808 Radio Manual FM Stereo/LW/MW/SW SSB AIR RDS Portable Digital Radio...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Radio - Front View................................2 Radio - Display................................. 3 Warning .....................................5 QUICK START GUIDE..............................5 FUNCTIONS & OPERATIONS EXPLAINED ......................5 1. FM Tuning range —— [ FM ] button ....................5 2. Medium Wave Step —— [ 9/10 kHz ] button .................. 6 3. -
Page 3: Radio - Front View
Radio - Front View Frequency / Page / Memory FM Band Select/ATS/Set FM Range MW/LW Band select / ATS / Enable LW Frequency / Page / Memory SW Band select / ATS / Scroll through Frequency / Page / Memory Meter bands Air Band select / ATS Frequency / Page / Memory... -
Page 4: Radio - Display
Radio - Display ⑪ FM RDS available ① Battery charge indicator ⑫ Frequency ② Sleep timer active ⑬ RDS Information ③ Key press beep active ⑭ ④ Alarm on USB / LSB mode ⑤ Frequency Display is kHz or MHz ⑮ Squelch acti ⑯... - Page 5 Radio - Side Controls External antenna jack (3.5mm) Volume control Headphone jack (3.5mm) Main Tuning knob(push in for FAST / SLOW / STOP) Fine tuning / clarify control for SSB USB Charging port Radio reset button access hole Radio-Rear Whip antenna used for FM, SW and AIR bands Kickstand Battery door (18650 battery included)
-
Page 6: Warning
Warning • Do not expose the radio to water, moisture or excessive humidity. • Operating temperature range is 0°- 40°C (32°—104°F). • Remove the battery immediately if liquid has been spilled or debris have fallen into the unit . • Clean with a dry cloth. Don’ t use detergents or chemical solvents. •... -
Page 7: Medium Wave Step--[ 9/10 Khz ] Button
2. Medium Wave Step——[ 9/10 kHz ] button The tuning step for medium wave (MW) can be set for 9 kHz or 10 kHz. To change the setting, turn the radio off and long-press the [9/10 kHz] button (number 0) ,and then press the button again to switch the two options, the current setting is displayed. -
Page 8: Beep--[ Beep ] Button
8. Beep——[ BEEP ] button The radio as it comes from the factory beeps after each key press. To disable this, turn the radio off and long-press the [BEEP] button (number 5). Long press the button to change the option. 9. -
Page 9: Up And Down Tuning Arrow
·Up and Down Tuning Arrow To search the frequency band starting with the current frequency: Select the desired frequency band, then long press the [Up or Down Tuning Arrow], the radio will start searching the selected frequency band, forward or backward, and stop searching after locating for a strong signal. -
Page 10: Bandwidth (Bw)
3. Bandwidth (BW) While radio signals are centered on one frequency, they actually occupy a range of frequencies. Sometimes two stations with adjacent frequencies can interfere with each other. This problem can be lessened by reducing the frequency range (bandwidth) the radio tunes. This feature is available on LW, MW and SW on this radio, but typically only used on SW. -
Page 11: Fm Rds (Radio Data System)
STEREO Some FM stations broadcast in stereo. In this case, STEREO appears on the display. Listening to the two stereo channels requires stereo headphones. Stereo can be turned off and on with the [FM ST] button. It may be automatically disabled for a weak signal. In some situations, you may get improved reception by turning stereo off. -
Page 12: Sw (Shortwave)
10. SW (shortwave) Fully extend the whip antenna and press the [ SW ] button to select the shortwave function and tune to the previously accessed shortwave frequency. Repeated presses of the button cycle through the 14 international shortwave broadcast bands The display shows which meter band is selected briefly after the button is pressed. -
Page 13: Fine Tuning
12. Fine Tuning In SSB mode, use the [FINE TUNE] knob on the right side of the radio. Turn it upward and the screen will display "FINE 1+99"; turn it downward and the screen will display "FINE 1-99", which is a function for fine-tuning the frequency. -
Page 14: Specifications
Specifications Radio bands: FM: 64 - 108 MHz AM(MW): 520 - 1710 kHz SW: 1711 - 29999 kHz LW: 150 - 450 kHz AIR: 118 - 137 MHz Sensitivity: FM: > 3 µV AM(MW): 0.5 mV/m SW: 10 mV/m LW: 10 µV AIR: 0.5 µV AM Selectivity: >... - Page 15 XHDATA Skype: radiwow E-mail: xhdatacn@gmail.com Facebook: Xhdata Radios Whatsapp: ＋8６ １80２５１９３２６７ Web：www.xhdata.com.cn ＹouTube：Xhdata Radio TikTok: XHDATAradio...
Need help?
Do you have a question about the D808 and is the answer not in the manual?
Questions and answers