Blomberg DWT37200 Use And Care Manual page 25

• Detergent is moist or clumping in
box.
• Using cutlery with a low surface
quality.
Possible causes
• Insufficient rinse aid supply.
• The hardness is not selected
properly; too little salt is being
used.
• Salt loss (models with salt
container)
Possible causes
• Smell of new machine.
• Filters are dirty.
• Dirty dishes standing in the
machine for a few days without
being washed.
• Dirty door gasket.
• Bleaches in cleaners lose their efficiency when
stored under unfavorable conditions. Store
detergents in a dry location. Close the lid of the
container securely.
• Cleaning of these items is made difficult by their
poor surface structure. Cutlery or dishes of this
type are not for dishwashers.
Calcium streaks, misty appearance
How to fix these problems
• Increase the dosage amount of rinse aid and/or
refill the rinse aid dispenser.
• Call water supplier and ask for local hardness in
grains per gallon or ppm. Use a higher phosphate
content detergent for hard water.
• Check whether the lid of the salt container is
firmly closed. Use the funnel to pour in special
salt. Begin the Rinse and Hold program right after
filling in salt. After the program is complete, check
whether the lid may have loosened.
Smell
How to fix these problems
• The smell of a new machine disappears after a
few wash cycles with detergent.
• Clean all filters as described in this manual.
• Remove coarse dirt under running water and run
the Rinse and Hold program every 2 days without
detergent.
• Regularly clean the door gasket with a damp
cloth to remove food particles and other debris.
Use a gentle household cleaner for the outside
and the door seals, and rinse thoroughly.
23
USA