Using The Audio Settings Of Quick Setup - Onkyo TX-NR717 Instruction Manual

Note
*1
• The video preview is not displayed when:
– HDMI IN 5/6/7 is the current HDMI input source, or
– No signal is present on the current input source.
• The video of the currently-selected input is displayed on the
main screen, not on a preview thumbnail.
*2 "Dynamic EQ" and "Dynamic Volume" cannot be selected
when any of the THX listening modes is selected, with
"Loudness Plus" set to "On" or "Preserve THX Settings" set
to "Yes" (➔ page 57).
*3 • When the "Monitor Out" setting is set to "Sub", "Video"
cannot be selected (➔ page 53).
• This setting cannot be used with the NET input selector.
*4
Only when you have selected "Custom" in the "Picture
(➔ page 63), pressing ENTER allows you to adjust
Mode"
the following items via the Quick Setup: "Brightness",
"Contrast", "Hue" and "Saturation". Press RETURN to
return to the "Picture Mode" setting.
*5 Depending on the input source and listening mode, not all
channels shown here output the sound.
*6 • This setting is not available in either of the following cases:
– The "Audio TV Out" setting is set to "On"
– "HDMI Control(RIHD)" is set to "On"
you're listening through your TV speakers.
Using the Audio Settings of Quick
Setup
You can change various audio settings from the Quick
(➔ page 48).
Setup
Note
• These settings are not available in either of the following cases:
– The "Audio TV Out" setting is set to "On"
– "HDMI Control(RIHD)" is set to "On"
you're listening through your TV speakers.
Tone Control
■
Bass
–10dB to 0dB to +10dB in 2 dB steps
You can boost or cut low-frequency sounds output
from the front speakers.
■
Treble
–10dB to 0dB to +10dB in 2 dB steps
(➔ page 67).
You can boost or cut high-frequency sounds output
(➔ page 67) and
from the front speakers.
You can adjust the bass and treble for the front speakers,
except when the Direct, Pure Audio or THX listening
mode is selected.
Operating on the AV receiver
1
Press TONE repeatedly to select either "Bass" or
"Treble".
2
Use – and + to adjust.
(➔ page 67).
(➔ page 67) and
En-49
Advanced Operations
Speaker Levels
■
Subwoofer Level
–15.0dB to 0.0dB to +12.0dB in 0.5 dB steps
■
Center Level
–12.0dB to 0.0dB to +12.0dB in 0.5 dB steps
You can adjust the volume of each speaker while listening
to an input source.
These temporary adjustments are cancelled when the AV
receiver is set to standby. To save the setting you made
(➔ page
here, go to "Level Calibration"
setting the AV receiver to standby.
Note
• You cannot use these function while the AV receiver is muted.
• These settings cannot be used while a pair of headphones is
connected.
• Speakers that are set to "No" or "None" in
"Speaker Configuration" (➔ page 55) cannot be adjusted.
56) before